The Lada Granta is equipped with modern electrical equipment, which increases the comfort and safety of the car. Electrical wiring in the Lada Granta connects all electronic and electrical devices, as well as their control elements. It has 2 fuse blocks. One of them, containing 5 power fuses, is located in the engine compartment immediately behind the battery. The other mounting block is located on the lower left side of the instrument panel, to the right of the headlight control module. The interior block of the Lada Granta in the “norm” configuration contains 32 fuses (including 6 reserve ones) and 12 relays.
Granta's electrical circuit is quite complex, and it is very difficult to understand it on your own without special education. Since there is no such diagram in the instructions supplied with the car, we will describe it in parts.
Front and rear wiring diagram
The wiring diagram for the front of the Lada Granta is quite simple, the main thing is not to confuse it with the wiring of the ignition system.
The following devices are available here.
Car front wiring diagram
- Right block headlight.
- Room lighting bulb.
- Left block headlight.
- Electric washer motor.
- Accumulator battery.
- Mounting block with power fuses.
- DC generator.
- Klaxon.
- The plug connecting the front wiring harness to plug 1 of the instrument panel.
- Plug connecting the front harness and plug 2 of the instrument panel.
- Plug connecting the front harness to plug 2 of the instrument panel.
- Reverse indicator switch.
- Radiator fan.
When replacing wiring, pay attention to the color of the wires. You can connect wires of certain colors only to those contacts to which they are connected in the diagram. If connected incorrectly, the fuses will constantly melt.
The electrical circuit for the rear of the car is more complex, it has more elements and connects to 6 wire harnesses.
Wiring diagram of the rear part of Granta
- Socket to connector 3 of the tidy.
- Socket to connector 4 of the tidy.
- Right side turn signal.
- Left side turn signal.
- Handbrake position sensor.
- Rear window heating element.
- Interior lighting lamp.
- The switch is in the driver's seat belt.
- Luggage compartment lighting.
- Fuel pump module.
- Right rear light.
- Trunk lock drive.
- Interior lighting switch.
- Stop signal.
- Left rear headlight.
- Clamp to the left rear door harness block.
- Clamp to the right rear door harness block.
- Clamp to the harness block of the right front door.
- Clamp to the left front door harness block.
- Airbag control unit.
- Clamp to the license plate light bulb harness block.
Return to contents
Grant liftback trunk lock with electric drive
Everyone is familiar with the usual method of installing an electric trunk lock using an actuator. The disadvantage of this design is that the rods create additional rattling noise while the car is moving. And the trunk lock of the Lada Granta has a built-in electric drive, which eliminates the appearance of extraneous noise. In addition, the trunk lid with the Grants lock closes more quietly and presses tightly enough.
- Electric trunk lock of the Lada Granta (catalog number 2190-5606010-10, note 2190-5606010-00 - the same lock, but without an electric drive).
- The counter part of the lock is from Granta (from Lada Kalina will not work).
- Metal corner (2 pcs) for attaching the lock.
- Washers, bolts, nuts.
- Lock connector for connecting an electric drive (the connector from the idle air control regulator is suitable).
The installation process is shown in the photo (tried on, drilled, secured). To leave the possibility of opening the trunk with the key, you will have to connect the rod in the same way.
Dashboard wiring
The electrical circuit of the instrument panel is the most complex, since it contains 34 devices. But you can figure it out too. Here is a list of available devices.
The instrument panel is a complex device
- The plug to which plug 9 of the front wiring is connected.
- Plug for connecting plugs 10 and 11 of the front wiring.
- The connector to which socket 1 of the rear wiring is connected.
- Connector for connecting socket 2 of the rear wiring.
- Control unit for dimensions, low beam, emergency lights.
- Mechanical ignition switch.
- Route bookmaker mode switch.
- Wiper switch.
- Dashboard.
- Light switch.
- Switch for the electric trunk lock.
- Diagnostic block.
- The connector to which the air intake box harness plug is connected.
- Rear window defroster switch.
- Emergency light switch.
- Brake light switch.
- Connector for connecting audio system speakers.
- The connector to which the car radio is connected.
- Device on the steering wheel.
- Driver's airbag module.
- Absent.
- Fuse block.
- Power steering (ESR).
- Cigarette lighter socket.
- Climate control console illumination lamp.
- Tidy light bulb.
- The socket to which the ignition system wiring plug is connected.
- Control device.
- Clutch pedal position indicator switch (only on cars with a manual gearbox).
- E-gas.
- Climate control system resistor.
- Electric motor for interior heater.
- Interior heater switch.
- Door lock control module.
The wiring diagrams for the Lada Granta ignition system vary depending on the type of engine installed, so when replacing the engine, the wiring of this system must also be changed.
Many car enthusiasts who independently “pump” their cars are wondering: how to properly connect the electrics? This question arises in almost any installation. After all, simply screwing on the blocks, locks and strips is not difficult, but only properly connected electricians can make the system work. If we take into account one of the most pressing problems - the installation of remote control locks for the fifth door, then the correct wiring diagram for the electric trunk lock will help us here. You can find it either in the instructions that should be included with the device, or you can take it from a reliable source, but it is better to use proven options and ask friends and acquaintances what scheme they used.
Installing an electric lock on the trunk of a Lada Granta
You can easily make the trunk of this car open when you press a button on the alarm remote control.
To do this, you need to follow the following algorithm:
- First, find the trunk opening control wire in the driver's door threshold wiring. You can determine it using a tester. When you press the trunk button in the cabin, a voltage of 12 volts should appear briefly. This is often a long green wire with a black stripe.
- Cut the cable and connect a 5-pin relay into the gap, which can be purchased separately with a connector or use what comes with the alarm.
- To create 12 volt power, the white and red wires must be connected together. You can take the permanent “plus” from the fuse block. In addition, you can unscrew the low beam control panel and connect to the pink wire.
- Connect the yellow wire to the green one. Twist its other end with the blue cable.
- Connect the black and yellow wire of the additional alarm channel to the black wire of the relay. Connect the second contact of the interior button here.
- Connect the first contact to the negative side of the on-board network. To do this, you can place the terminal under the nut of the standard mounting bolt. As a result, when you press the interior button, the trunk will always open.
In addition, you can open the cover by pressing the key combination of the alarm key fob. Moreover, such an operation does not require disabling the car alarm.
An additional button installed inside the cabin in the place provided by the manufacturer makes it possible to open the trunk in reserve. Such an improvement can extend the life of a standard street button, the replacement of which will be quite expensive due to its labor intensity.
Preparation for installation
We purchase a lock kit. There are a lot of manufacturers of auto parts on the market now, but there are no special differences between the sets. It is important that the device has a warranty card and instructions for use and connection. Also in the box you will find:
Additionally, you need to stock up on a set of standard tools: pliers, screwdriver, screwdrivers, multimeter, drill with carbide drill bit. In addition to the standard accessories, immediately buy additional wires; it is quite possible that the length of those you find in the box will not be enough for you. Black heat-resistant insulating tape, corrugated tubes, and clips for fastening the trim will also be useful, since very often the trim of car elements is attached to disposable ones.
Important! Be sure to check that the warranty card for the purchased device is available and filled out correctly. Regardless of who performed the installation, you or the service, you have the right to free repairs within a year.
Self-installation
First of all, it is necessary to secure the electric drive to the trunk lid and provide it with a mechanical connection to the lock itself. To do this, you will have to make two cuts on the lock, and bend the resulting free “tongue”. Thus, we gained access directly to that part of the lock, by pulling which the trunk lid will open. Now we attach the long metal stick from the kit so that the lock can close when the system is operating. It is quite possible that you will have to cut off extra centimeters of this pin.
Now our device is installed properly and all that remains is to connect the electrics. To do this, we will use the diagram below.
Important! When working with electrical equipment, remove the battery!
In most cars, electrics operate on 12V positive voltage. However, if you doubt that everything is the same for you, it is better to check with the car dealer and not use this diagram for connection. It is very important to make the correct connection of the wires, since the proper operation of your car as a whole depends on it. At best, some options will simply not work correctly; at worst, a short circuit will occur. And it is not always possible to restore the electrics and electronics of the car after it. And this work will cost a lot of money. In addition to the above, lay wires where standard wiring is already laid. In difficult places, for example, when you have to pull the wire from the passenger compartment to the trunk, it is necessary to use protective corrugated tubes.
Trunk lid lock for VAZ 2190 Lada Granta with electric drive
Dear customers, in order to avoid mistakes when sending the trunk lid lock with electric drive of the VAZ 2190 Lada Granta, in the “Comment” line, indicate the model of your car, year of manufacture.
The trunk lock 2190-5606010-10 with an electric drive (activator) ensures automatic opening of the trunk lid of the Lada Granta, which significantly simplifies the life of the driver of this vehicle.
The automatic trunk opening function is a fairly new option, the existence of which most car owners of new car models are just beginning to get used to.
The essence of the operation of the activator (electric drive), which makes it possible to achieve such a result, is, in principle, not complicated: when someone presses the corresponding button in the car interior, the trunk lid lock is activated through this part, as a result of which it opens.
It’s a small thing, but it makes life so much easier for vehicle owners, especially during the cold season (the keyhole freezes). This device is compatible with a standard (mechanical) lock, which means that when opening the luggage compartment lid, you can use two methods simultaneously, which, by the way, increases resistance to burglary.
Today, there are two types of drives that, in order to open the trunk lid, bring the rod into working condition - this is a mechanism that has either an electric motor or magnetic plates.
The first is more common, as it is quite practical and durable, and the second, due to the complexity of the design and frequent problems with use, has not gained much popularity among car enthusiasts.
When using a VAZ 2190 Lada Granta trunk lid lock with an electric drive, the luggage compartment can be opened using the remote control key fob button, or using a button mounted in the luggage compartment lid.
The trunk lid lock 2190-5606010-10 with an electric drive for the Lada Granta is certainly a useful and necessary thing, but only if its installation is justified.
Other article numbers of the product and its analogues in catalogues: 21900560601010.
Any breakdown is not the end of the world, but a completely solvable problem!
How to install and replace the electric trunk lid lock on a Lada Granta car yourself.
